The saliva sample as a slide for the sample holder
· by Peter A. Giger · 2 min read
The tube from the sample kit does not fit into the sample holder. This is how a drop of saliva becomes a flat slide that fits into the holder and keeps for a long time.

Starting point
The saliva sample comes in the tube of the sample kit. With the stabiliser inside, it remains usable for about six months. The sample space in the holder, however, measures only 25 × 25 millimetres and is at most 4 millimetres high. So the tube does not fit.
The solution is a small slide made of two cover glasses with a piece of filter paper between them holding a drop of the sample. It is about half a millimetre thick and can be made separately for each output.
Materials
Cover glasses 20 × 20 mm from a laboratory supplier white coffee filter paper (does not shed fibres and stays flat, better than kitchen paper) gloves, a pipette or a toothpick clear adhesive tape or colourless nail varnish
Labelling and assigning
It is not the slide that is labelled but the holder, from the outside, with the person's identifier and the output in which the sample lies. A small label is enough.
A slide outside the holder goes straight into a labelled bag. The tube stays closed in the refrigerator. New slides are made from it as needed, one per output and one for the Sample Digitizer. After about six months a new sample is requested.
Step by step
- Put on gloves. Wipe the cover glasses with alcohol and let them dry.
- Cut coffee filter into squares of about 12 × 12 mm. A small supply saves time later.
- Put one drop from the sample tube onto a square. The paper absorbs it.
- Let it dry completely, 30 to 60 minutes, protected from dust, not in the sun and not on the radiator.
- Place the dry paper between two cover glasses and seal the edges all round with tape. The slide now measures about 20 × 20 mm and is around 0.5 mm thick.
- Never place a cover glass on a wet drop. Otherwise it is squeezed out at the sides.
Peter A. Giger
Articles ›